The i4 Flashlight application will turn you iPhone 4 into a high powered LED flashlight. Designed specifically for the iPhone 4 and will only work on the iPhone 4. Clean design makes turning on and off the flashlight effortless and easy. It runs within an application window keeping the phone's status bar visible allowing you to monitor your phones battery and signal within the application. Two modes of operation: Continuous light and Safety blinking light.
"Continued use of the flash may dramatically decrease battery life."
If you have the iPhone 4 then this is a must have utility application. You never know when you might need a good strong flashlight or a safety light and now you will never be without one.
How it works: Next to the iPhone 4's rear facing camera is a high powered white LED light. This light is used by the iPhone's camera to illuminate subjects in low light conditions for still photos and video. The i4 Flashlight application utilizes this hardware white LED light in order to allow you to operate it as a continuous light source or a blinking safety light.
Interface: Keep it simple user interface where form follows function. It just works. A large single push button turns on the flashlight. There is an additional option switch that activates the safety blinking light that can be used for emergencies or just for fun.
There is no doubt about it, this LED FlashLight is bright!
System Requirements: This application was designed specifically for the iPhone 4. It will only run on the iPhone 4 or later device with a hardware LED Flash component. If you have an earlier version of the iPhone this application will not operate. Please do not install unless you have an iPhone 4.